How to add and reset AduroSmart products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

 

How to add and reset AduroSmart products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Use the provided pin to press and hold the reset button for 10 seconds.
  2. Battery-powered Zigbee devices often pair easier when their batteries are removed for 10 seconds following a factory reset.

Join the Zigbee Network

  1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
  2. Use the provided pin to press and hold the reset button for 10 seconds.

Leaving the Zigbee Network

  1. From the device's details page, select Remove Device, then Remove.

Brand

Device

Product Number

Device Type

Protocol

AduroSmart

Door / Window Sensor

ERIA 81822

Contact Sensor

Zigbee

Brand

Device

Product Number

Device Type

Protocol

AduroSmart

Dimmer Switch

ERIA 81825

Button Controller

Zigbee

Factory Reset

  1. Hold down the two middle buttons until the light flashes green. A red flash indicates an unsuccessful reset.
  2. Battery-powered Zigbee devices often pair easier when their batteries are removed for 10 seconds following a factory reset.

Join the Zigbee Network

  1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
  2. Hold down the off (circle) button for 10 seconds until it flashes green 3 times.

Leaving the Zigbee Network

  1. From the device's details page, select Remove Device, then Remove.

Brand

Device

Product Number

Device Type

Protocol

AduroSmart

Motion Sensor

ERIA 81823

Motion Sensor

Zigbee

Factory Reset

  1. Use the provided pin to press and hold the reset button for 10 seconds.
  2. Battery-powered Zigbee devices often pair easier when their batteries are removed for 10 seconds following a factory reset.

Join the Zigbee Network

  1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
  2. Use the provided pin to press and hold the reset button for 10 seconds.

Leaving the Zigbee Network

  1. From the device's details page, select Remove Device, then Remove.