How to add and reset Evolve products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Evolve products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Factory reset is unavailable for this device. Instead, perform a general exclusion.
  2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  3. Exclude the module by tapping the button 3 times, then press and hold for 10 seconds.
  4. LFM-20 release 5.41 requires that you tap 2 times, then press and hold for 10 seconds.

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. Press the button on the device once to include it in the Z-Wave network.

Exclusion from the Z-Wave Network

  1. From the device's details page, select Remove Device, then Remove
  2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  3. Exclude the module by tapping the button 3 times, then press and hold for 10 seconds.
  4. LFM-20 release 5.41 requires that you tap 2 times, then press and hold for 10 seconds.

Device

Product Number

Device Type

Protocol

Isolated Contact Fixture Module

LFM-20

Relay

Z-Wave