How to add and reset Graber products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Graber products on Hubitat Elevation hub

 

2. Resolution

Network Reset

  1. Press and hold the button on the headrail end cap for 7 seconds or until the shade jogs once.
  2. Release the button.
  3. They will not reset the shade limits 

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. Place the single-channel remote in programming mode by pressing and holding the programming button until the LED light bar begins to flash Green.
  3. Release the button.
  4. Successful inclusion will be confirmed by Hubitat Elevationâ„¢
  5. Watch the status on the device details page to confirm proper operation.

Exclusion from the Z-Wave Network

  1. From the device's details page, select Remove Device, then Remove
  2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  3. Place the single-channel remote in programming mode by pressing and holding the programming button until the LED light bar begins to flash Green.
  4. Release the button
  5. The shade will be excluded from the Z-Wave network.

Brand

Device

Product Number

Device Type

Protocol

Graber

Motorized Shades

Shade

Z-Wave