How to add and reset Halo Labs products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Halo Labs products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. To reset, hold the down center button for approximately 20 or more seconds.

Join the Zigbee Network

  1. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
  2. Once Halo greets you, it will automatically begin searching for a ZigBee network. Halo will glow for a couple of minutes before timing out.
  3. To awaken the detector, double-tap the center button or hold the button for approximately 3 or more seconds.

Leaving the Zigbee Network

  1. From the device's details page, select Remove Device, then Remove
  2. Hold down the center button for approximately 20 or more seconds. Halo will reset all ZigBee settings and leave the network.

Device

Product Number

Device Type

Protocol

Halo+

LS001A

Smoke/CO Detector

Zigbee