How to add and reset Heiman products on Hubitat Elevation hub
Authored by: Support.com Tech Pro Team
1. Introduction
How to add and reset Heiman products on Hubitat Elevation hub
2. Resolution
Factory Reset
Plug in the gas detector. It will beep once and the indicator light will flash Green once.
Before the detector Zigbee radio can be reset, the gas detector must be in a ready state. The indicator light will alternate Red and Yellow while it is warming up.
After approximately 3 minutes, the detector indicator light will stop flashing Red and Yellow. It will now have a steady Green indicator light, denoting it is ready and has ented its working state.
Using the included tool or a straightened paperclip inserted in the small hole on the side, press the reset button for 2 seconds.
The Green indicator light will flash quickly, and after 3 seconds it will turn off briefly and then return to steady Green indicating thedetector has returned to its ready state.
Join the Zigbee Network
Plug in the gas detector. It will beep once and the indicator light will flash Green once.
Before the detector Zigbee radio can be reset, the gas detector must be in a ready state. The indicator light will alternate Red and Yellow while it is warming up.
After approximately 3 minutes, the detector indicator light will stop flashing Red and Yellow. It will now have a steady Green indicator light, denoting it is ready and has ented its working state.
From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
Using the included tool or a straightened paperclip inserted in the small hole on the side, press the reset button for 2 seconds.
The Green indicator light will flash quickly, and after 3 seconds it will turn off briefly and then return to steady Green indicating thedetector has returned to its ready state.
Leaving the Zigbee Network
Ensure the gas detector is plugged ing and ready.
Before the detector Zigbee radio can be reset, the gas detector must be in a ready state. The indicator light will alternate Red and Yellow while it is warming up.
After approximately 3 minutes, the detector indicator light will stop flashing Red and Yellow. It will now have a steady Green indicator light, denoting it is ready and has ented its working state.From the device's details page, select Remove Device, then Remove
From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
Using the included tool or a straightened paperclip inserted in the small hole on the side, press the reset button for 2 seconds.
The Green indicator light will flash quickly, and after 3 seconds it will turn off briefly and then return to steady Green indicating thedetector has returned to its ready state.