How to add and reset MCO Home products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset MCO Home products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Press 10 times any button or exclude the device from the Z-Wave network, then cut off the main power.
  2. The factory setting will be restored.

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. Press 3 times on the "+" or "-" button to add the device. If successful, the green LED flashes 4 times.
  3. If an external switch is wired to the dimmer, you may also toggle that 3 times to add the device to the network. 

Exclusion from the Z-Wave Network

  1. From the device's details page, select Remove Device, then Remove
  2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  3. Press 3 times on the "+" or "-" button to exclude the device from the network. If successful, the green LED flashes 4 times.
  4. If an external switch is wired to the dimmer, you may also toggle that 3 times to add the device to the network. 
  5.  

Device

Product Number

Device Type

Protocol

Dimmer Switch

MH-DT311

Dimmer

Z-Wave