How to add and reset NanoLeaf products on Hubitat Elevation hub
Authored by: Support.com Tech Pro Team
1. Introduction
How to add and reset NanoLeaf products on Hubitat Elevation hub
2. Resolution
Factory Reset
Disconnect power to the Nanoleaf Light Panels.
Hold the Toggle and Power buttons together and reconnect the power without releasing the buttons.
After about 7 seconds, the WiFi status LED will start to flash rapidly.
Once the flashing begins, you can release the buttons.
You must then wait 3 minutes for the Nanoleaf Light Panels to reset to factory default settings and boot up.
Join the LAN
Use the NanoLeaf Smarter Series app from your mobile device to set up your light panels on the WiFi network.
From the Hubitat Web Interface home page, select Devices, then Add Virtual Device
Name your device and select NanoLeaf Aurora from the Device Type drop-down menu, and press Save.
In the Preferences field of the driver, enter the IP address of your Nanoleaf panel.
You should reserve the IP address for your NanoLeaf light panels in your router just as you do for your Hubitat Elevationâ„¢ hub. If you do not, the IP address will change when the DHCP lease on your router expires for connected IP devices. The result will be that the Nanoleaf Aurora driver will no longer be able to find your device.
Press Save again in the driver.
One your NanoLeaf panel, press the pairing button.
In the NanoLeaf Aurora driver, press the Get Auth Token button.
Test your panel for proper operation.
Leaving the LAN
From the device's details page, select Remove Device, then Remove
Plug your Light Panels into power. After a 1 minute bootup sequence the panels will show the last scene that was playing
Press and hold down the Effect Select and Power buttons on the controller for about 10 seconds, until the LED on the controller begins flashing
Release the two buttons and the LED on the controller will remain on and steady
Delete the previous device from the app and setup once again
.png)
