How to add and reset Orvibo products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Orvibo products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Hold down the reset button on the front of the motion sensor until the Green light goes out.
  2. This will disconnect the sensor from the Zigbee network.
  3. Short-press the reset button and the Green light will flash slowly.
  4. The sensor is now in pairing mode.

Join the Zigbee Network

  1. Remove the cover by rotating it counterclockwise
  2. From the Hubitat Web Interface home page, select Zigbee on the Device Discovery page to start device discovery.
  3. Hold down the reset button on the front of the motion sensor until the Green light goes out.
  4. This will disconnect the sensor from the Zigbee network.
  5. Short-press the reset button and the Green light will flash slowly.
  6. The sensor is now in pairing mode.

Leaving the Zigbee Network

  1. From the device's details page, select Remove Device, then Remove.
  2. Hold down the reset button on the front of the motion sensor until the Green light goes out.
  3. This will disconnect the sensor from the Zigbee network.

Device

Product Number

Device Type

Protocol

Motion Sensor

SN11

Motion Sensor

Zigbee