How to add and reset Powerly products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Powerly products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. To reset to factory defaults, turn the thermostat off by pressing Mode repeatedly until OFF scrolls across the display.
  2. Press and hold the down and up Setpoint arrows at the same time for 5 seconds.
  3. If successful, RESET will scroll across the display and the device will be restored to its default settings.

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. To put your thermostat into inclusion mode, press and hold Mode for 5 seconds.
  3. CONNECT will scroll across the thermostat display once in inclusion mode.
  4. SUCCESS will scroll across the thermostat display once included, but FAIL will scroll across the thermostat display if inclusion is unsuccessful,

Exclusion from the Z-Wave Network

  1. To exclude your Thermostat, press and hold Mode for 5 seconds to initiate the Z-Wave exclusion process.
  2. DELETE will scroll across the thermostat display once in exclusion mode. If you need to cancel the exclusion process, press Mode.
  3. To complete exclusion, press either the up or down arrow.
  4. SUCCESS will scroll across the thermostat display once excluded.

Device

Product Number

Device Type

Protocol

Thermostat

NIL

Thermostat

Z-Wave