How to add and reset Shelly products on Hubitat Elevation hub
Authored by: Support.com Tech Pro Team
1. Introduction
How to add and reset Shelly products on Hubitat Elevation hub
2. Resolution
Factory Reset
If the device has been powered on, power it off and then on again.
After turning the power on, you have 60 seconds to press 5 consecutive times on a connected switch.
Alternatively, if you have physical access to the device, press and hold the reset button for 10 seconds.
When the LED indicator starts to flash quickly, release the button and your device should return to AP Mode.
Join the LAN
In the Preferences field of the driver, enter the IP address of your Shelly device.
You should reserve the IP address for your Shelly WiFi devices in your router, just as you do for your Hubitat Elevationâ„¢ hub. If you do not, the IP address will change when the DHCP lease on your router expires for connected IP devices. The result will be that the Shelly driver will no longer be able to find your device.
Leaving the LAN
From the device's details page, select Remove Device, then Remove.
If the device has been powered on, power it off and then on again.
After turning the power on, you have 60 seconds to press 5 consecutive times on a connected switch.
Alternatively, if you have physical access to the device, press and hold the reset button for 10 seconds.
When the LED indicator starts to flash quickly, release the button and your device should return to AP Mode.
Device
Product Number
Device Type
Protocol
WiFi Dimmer
NIL
Dimmer
LAN
Device
Product Number
Device Type
Protocol
WiFi Switch
NIL
Switch
LAN
Factory Reset
If the device has been powered on, power it off and then on again.
After turning the power on, you have 60 seconds to press 5 consecutive times on a connected switch. You will hear the relay trigger itself.
After the relay makes a triggering sound, the switch should return to AP Mode.
Alternatively, if you have physical access to the device, press and hold the reset button on the back of the device for 10 seconds.
Your device should return to AP Mode.
Join the LAN
In the Preferences field of the driver, enter the IP address of your Shelly device.
You should reserve the IP address for your Shelly WiFi devices in your router, just as you do for your Hubitat Elevationâ„¢ hub. If you do not, the IP address will change when the DHCP lease on your router expires for connected IP devices. The result will be that the Shelly driver will no longer be able to find your device.
Leaving the LAN
From the device's details page, select Remove Device, then Remove.
If the device has been powered on, power it off and then on again.
After turning the power on, you have 60 seconds to press 5 consecutive times on a connected switch.
Alternatively, if you have physical access to the device, press and hold the reset button for 10 seconds.
When the LED indicator starts to flash quickly, release the button and your device should return to AP Mode.