How to add and reset Telguard products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

 

How to add and reset Telguard products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Plugin the GDC1.
  2. Remove the cover of the enclosure.
  3. Press the Z-Wave button once to reset the device.

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. Press the Z-Wave button once to join the GDC1 for your Z-Wave network.
  3. If the device fails to join the Z-Wave network, unplug it for 10 seconds.
  4. Repeat step 1 and again press the Z-Wave button.
  5. Replace the cover of the enclosure.

Exclusion from the Z-Wave Network

  1. Plugin the GDC1.
  2. Remove the cover of the enclosure.
  3. From the device's details page, select Remove Device, then Remove.
  4. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  5. Press the Z-Wave button once to exclude the GDC1 from the Z-Wave network.

Device

Product Number

Device Type

Protocol

Garage Door Control Switch

GDC1

Switch

Z-Wave