How to add and reset Vision products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

 

How to add and reset Vision products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Remove the mounting bracket and press the program button for at least 1 second & release.
  2. The LED light will turn flash indicating the device is reset to factory defaults and excluded from the Z-Wave network.

Join the Z-Wave Network

  1. The distance between the siren and the hub is suggested to be 1 meter ( 3 feet ) or less.
  2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  3. Remove the mounting bracket and press the program button for at least 1 second & release.
  4. The LED light will turn off after inclusion.
  5. If the device is not included, it will continue to auto-include more, attempting every 4-6 seconds for up to 4 attempts.
  6. The LED light will flash again if the siren has not been included.

Exclusion from the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  2. Remove the mounting bracket and press the program button for at least 1 second & release.
  3. The LED light will turn flash upon successful exclusion from the Z-Wave network.

Device

Product Number

Device Type

Protocol

Siren & Strobe

ZM1601US-3

Siren

Z-Wave

Device

Product Number

Device Type

Protocol

Siren & Strobe

ZM1601US-5

Siren

Z-Wave

Factory Reset

  1. Remove the mounting bracket and press the program button for at least 1 second & release.
  2. The LED light will turn flash indicating the device is reset to factory defaults and excluded from the Z-Wave network.

Join the Z-Wave Network

  1. The distance between the siren and the hub is suggested to be 1 meter ( 3 feet ) or less.
  2. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  3. Remove the mounting bracket and press the program button for at least 1 second & release.
  4. The LED light will turn off after inclusion.
  5. If the device is not included, it will continue to auto-include more, attempting every 4-6 seconds for up to 4 attempts.
  6. The LED light will flash again if the siren has not been included.

Exclusion from the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  2. Remove the mounting bracket and press the program button for at least 1 second & release.
  3. The LED light will turn flash upon successful exclusion from the Z-Wave network.

Device

Product Number

Device Type

Protocol

Shock Sensor

ZS5101

Acceleration Sensor

Z-Wave

Factory Reset

  1. Push the Tamper switch while inserting the battery & holding the Tamper switch for 5 seconds
  2. The device will reset to the factory defaults and the LED will remain ON solid
  3. Remove the battery and re-insert it to complete the reset process.

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. Press the program button for at least 1 second & release.
  3. The LED light will turn off after inclusion.

Exclusion from the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  2. Press the program button for at least 1 second & release.
  3. The LED light will turn off after exclusion.