How to add and reset Zipato products on Hubitat Elevation hub

Authored by: Support.com Tech Pro Team

1. Introduction

How to add and reset Zipato products on Hubitat Elevation hub

 

2. Resolution

Factory Reset

  1. Press tamper key 4 times within 1.5 seconds, but do not release the tamper key in the 4th press.
  2. The LED will stay ON solid for 3 seconds and then will turn OFF.
  3. Within 2 seconds of the LED turning OFF, release the tamper key. If successful, the LED will turn ON for 1 second.
  4. If reset fails, the LED will flash once.

Join the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Inclusion on the Device Discovery page.
  2. Press the tamper key 3 times within 1.5 seconds to enter inclusion mode.
  3. After successful inclusion, the LED will light up for 1 second.

Exclusion from the Z-Wave Network

  1. From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Exclusion on the Device Discovery page.
  2. Press the tamper key 3 times within 1.5 seconds to enter exclusion mode.

Device

Product Number

Device Type

Protocol

Siren

PH-PSE02

Lock

Z-Wave